Holden Cruze, Trax, Barina 3 Button Replacement Car Key Shell Case AOHO-CK02

Holden Car Key Case Replacement Compatibility

This Auto Openers AOHO-CK02 will replace your old and worn out Holden or Chevrolet car key case and shell. Below are some of the Holden car models that use this car remote. Ensure that your car remote and buttons look the same as pictured.

Holden Car Key Models

• Barina (TM) 2011 – 2014
• Cruze (JG) 2009 – 2010
• Cruze (JH) 2010 – 2014
• Trax 2013 – 2014
• Holden VF Commodore

Chevrolet Car Key Models

• Camaro 2010 – 2013
• Cruze 2011 – 2013
• Equinox 2010 – 2013
• Malibu 2013
• Spark 2013
• Sonic 2012-2012
• Volt 2011-2013

If you are not sure if this will suit, please send us a photo of your car remote so we check for you.

How Do I Replace My Holden Key Case?

Replacing the buttons on your Holden car key remote is very simple and can be done by anyone. You only need a small, flathead screwdriver (or similar tool) and 1 minute.

1. Press the button to open the key blade on your old car key, which will reveal a small hole in the side of the car key case.’

2. Insert a screwdriver into that hole and pry open the case, but be careful! There will be a spring that is under some tension and can fall out.

3. Remove the internal circuit board and key blade. Please check your circuit board to ensure that the transponder is present on the circuit board. This is a small, rectangular chip present on the pointed part of the circuit board. If it is not present, check the top right portion of the keycase. It will need to be moved over.

4. Insert the circuit board, transponder and transponder cover into the new car key case.

5. Click and screw together the new case, then test to ensure that everything is working fine.