AUTOOL SDT205 Smoke Leak Detector, 2 Mode Automotive Fuel Leakage Diagnostic Tester,Conduit Pipe System Leakage Tester,EVAP Leak

Technical Indicators:

Power Supply: DC12V±2
Output pressure：≈1kg/c㎡
Output smoke：1-6L/min
Dimensions: 350x235x300mm
Total weight：5.5kgs
Ambient temperature: -10 ℃ ~ + 40 ℃
Relative humidity: No open fire within 2 meters of radius in the surrounding area.

Operational Steps

Operational Steps for Air Intake System Test
Open the air filter cover and take out the air filter. Take out the inflatable bladder from the accessory box and continue to squeeze it until the inflated diameter of the rubber bladder matches the diameter of the air inlet.
Remove the oil filler cap, add 10ml of test oil into it, and tighten the cap.
Turn on the power switch. Then press the air mode button and the smoke mode button respectively.
Block the smoke nozzle and watch the pressure gauge.
When the pressure reaches 0.8kg / cm2, please connect it to the inflatable bladder.
After that, you can find out if there is smoke coming out from the leak point of the air intake system.

Operational Steps for EVAP System Test

Find the carbon canister on the car, and disconnect the fuel inlet/outlet tubing. Take out the special adapter for EVAP system from the accessory box and connect it to the tubing you want to test.
Remove the oil filler cap, add 10ml of test oil into it, and tighten the cap.
Turn on the power switch. Then press the air mode button and the smoke mode button respectively.
Block the smoke nozzle and watch the pressure gauge.
When the pressure reaches 0.8kg / cm2, connect the smoke nozzle with the special adapter for EVAP system.
After that, you can find out if there is smoke coming out from the leak point of the EVAP system.
Attention:
Please make sure there are no open flames in the process of EVAP system test.